FRP Channel Type Cable Trays (Perforated)
Our channel type cable trays with a solid bottom are purposefully designed to cater to light loads, specifically suited for the management of instrumentation and control cables. These trays are also exceptionally well-suited for facilitating smooth transitions from larger cable trays to individual control points within your infrastructure.
FRP / GRP cable trays are good replacement of G.I / M.S cable trays, which tend to corrode, erode and spread heat thus leading to power interruptions.
On the other hand FRP cable trays safe, durable, cost effective and easy to install. FTC manufactures these cable trays as per NEMA / BIS / Consultants Specification.
Advantages of FRP / GRP Perforated Cable Trays
- Corrosion resistance
- Light weight so easy to move and place
- Excellent electrical insulation properties
- Very high strength to weight ratio
- No earthing required
- Very low thermal conductivity
- U.V resistant
- Impact resistant – returns to original position without any permanent deflection or distortion
- Non-toxic
- Easy to install
- Long life cycle
Standard specification is available as per below table
| Inside Width | Load Design | Material Choice |
| 50mm | 10kg/mtr. | Polyester/Vinyl |
| 75mm | 12kg./mtr. | Polyester/Vinyl |
| 100mm | 15kg/mtr. | Polyester/Vinyl |
| 150mm | 18kg/mtr. | Polyester/Vinyl |
| 200mm | 25kg/mtr. | Polyester/Vinyl |
| 300mm | 30kg/mtr. | Polyester/Vinyl |
| 450mm | 40kg/mtr. | Polyester/Vinyl |
| 500mm | 45kg/mtr. | Polyester/Vinyl |
| 600mm | 50kg/mtr. | Polyester/Vinyl |